Lighting cautions

Anything that might not belong on the other message boards!

Moderator: Team Cub

Forum rules
1. Keep it clean.
2. Keep the discussion civil.
3. Name calling is not allowed.

Politics and religion are two topics that tend to degenerate into a violation of one of the three simple rules above.

The mods and the site admin reserve the right to "lock" or "delete" any discussion that in our opinion, is "heading in the wrong direction."

MOST of all, be respectful of your fellow Cubber's opinions. Don't expect to change someones belief system from a simple forum on the internet.

Lighting cautions

Postby Bus Driver » Fri Dec 14, 2012 9:22 am

Incandescent lamps will "digest" any power fed to them as long as the rated voltage is not exceeded. AC, DC, varying Hz-- no matter. LEDs and fluorescents use some electronics to make changes to the incoming power, the LED unit is called a "driver" and the fluorescent is called a "ballast". The power fed to those units usually must be the 120 volt 60Hz for the USA, and presumably for much of Canada. Lighting units marked "not dimmable" require the 120 volt, 60 Hz.
Electronic timers, dimmers, remote control units and many of the day/night sensors have an output that is not the 60Hz and can potentially damage the non-incandescent lighting units.
Units that are marked as suitable for dimmers may list the acceptable dimmers.
Luck favors those who are prepared
User avatar
Bus Driver
Team Cub Mentor
Team Cub Mentor
 
Posts: 2620
Joined: Sat Feb 11, 2006 5:26 pm
Location: NC

Return to Off Topic

Who is online

Users browsing this forum: No registered users and 2 guests