Page 1 of 1

Reproduction IH Carb - Two Thumbs Up

Posted: Tue Jul 10, 2012 9:02 am
by CPIII
Well a few monnths ago I broke down and bought a new carbuerator off of Ebay. It was one of the reproduction IH carbs. When I first installed it it would crank very easily but then die after about 20 to 30 seconds. I took it apart and adjusted the float travel and that solved that issue. I have been running it ever since and just wanted to say that it is working very well and I am very pleased with it. Other than adjusting the float travel it has been hands off wonderful.

Just wanted to share my experience with this reproduction carb

CPIII

Re: Reproduction IH Carb - Two Thumbs Up

Posted: Tue Jul 10, 2012 9:46 am
by Anonymous_h
I too purchased one of these aftermarket 3/4" updraft carbs a few years ago and have had no issues with it at all.

Re: Reproduction IH Carb - Two Thumbs Up

Posted: Wed Jul 11, 2012 12:37 pm
by SundaySailor
Homstead wrote:I too purchased one of these aftermarket 3/4" updraft carbs a few years ago and have had no issues with it at all.


Same here. Mine was purchased from TMTractor when he stocked them.