Product & services reviews. Lubricants, rust removers, hoists, tools, powder coating, etc.
Post your personal experiences with products and services here.
PLEASE: Do not post bad reviews until all attempts to reach an equatable settlement have all been exhausted. (Attempts to use the forum to leverage a settlement in your favor will result in deletion of your review.)
Tue Oct 21, 2008 6:03 pm
I use this stuff for all my seals and gaskets where fuel and oil is involved. It will fill in any imperfections in the metal that would otherwise lets fluids seep past over time. **It is not a gasket maker, not designed to be used by itself.** This little bottle will last a very long time, it has a 'dauber' on the end of a stick attached to the lid. Little bit goes a long way. If put on and allowed to tack, will hold the gasket/seal in place while you are trying to hold the part, line up holes, reaching for bolts and wrench all at the same time. Use it and I believe you'll like it.
Availabe at any auto parts store: Autozone, Discount, NAPA, etc...
"Hard setting, economical sealant. Seals all common gasketing materials in low temperature and low pressure applications. Temperature range -65Â°F to 350Â°F (-54Â°C to 177Â°C); resists diesel fuels and most shop fluids"
Tue Oct 21, 2008 6:11 pm
Raymond, how difficult is it to remove when it comes time to replace the gasket?
Tue Oct 21, 2008 6:39 pm
Aerosol Carb cleaner will take it off. If you are like me, I tend to get it all over my fingers while using it, have a can ready if you use it!
Wed Oct 22, 2008 6:08 pm
A very old but good product that has been around forever.
Wed Oct 22, 2008 9:27 pm
Been using that stuff for 30 years easy, works good
Sun Nov 30, 2008 10:16 pm
I use it on my head bolts to seal them.
Wed Mar 11, 2009 3:36 pm
I've used this on my ford truck engine flathead gaskets . It works great
Sun Aug 02, 2009 4:49 pm
Stick, I did not think anyone was still using that but me. I have a glass bottle of it, you know how old that is
. It works well for keeping head bolts from leaking water where they go into a water jacket. Very good to coat the outside of seals before installing. That is what I use on the rear crank seal .
Sun Aug 02, 2009 4:58 pm
I use it.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.