In The Shop

[Rudi]

This chapter will contain topics relating to Tools, Jigs, Safety and specialized parts repair topics.

All About Safety


Tractor Safety


1. How To Safely Disassemble A Culti-Vision Tractor
   
2. How To Properly Hand Crank A Cub


Shop Saftey

1. How To Remove That Oil Spot From Your Concrete Floor

Specialized Parts Repair



1. How To Get Your Early Style Seal & Retainer Upgraded
   
2. How To Helicoil A Stripped Carb Fuel Inlet Port in an IH 3/4" Updraft Carb
3. How To Install Threaded Inserts in the Transmission Case

Storage Options For Your Cub Parts



1. How To Make A Tear Drop Lens Storage Case

[Rudi]

All About Tools, Jigs, Special Parts and Equipment


Jigs and Custom Tools


1. How To Decide Which Taps Are Needed For My 3/4" IH Carb
   
2. How To Make A Bottoming Tap - Method # 1
3. How To Make A Bottoming Tap - Method # 2
4. How To Make A Block and Radiator Lower Casting Flushing Tool
5. How To Make Fuel Shutoff Valve Tools
6. How To Make A DIY Clutch Alignment Tool
7. How To Keep Track of Elusive Drain Plugs
8. How To Make A Crank Shaft Wrench
9. How To Build A Large Backyard Parts Cleaner
10. How To Make Your Own Touch Control Regulator Valve Seat Removal Tool
11. How To Make An Updraft Carb Straightening Jig
12. How To Make a Simple Platform to Straighten Warped Carb Tops

[Rudi]

All About Tools, Jigs, Special Parts and Equipment


Cub and Implements Parts



• How To Make A Steel Gas Line For Your Cub
  
• How To Install an In-Line Filter in 5/16" Steel Gas Line
• How To Make A Touch Control Reservoir Fill Port Adapter
• How To Make A Touch Control Reservoir Fill Port Extension
• How To Make A Touch Control By-Pass Block
• How To Make Jumper Tabs
• How To Build A Replacement Battery Cable
• How To Make Gaskets - Tap Method
• How To Make A Replacement Clutch Inspection Hole Cover
• How To Make A Cub-22 Mower Pulley
• How To Make Replacement Implement Bolts - Method #1
• How To Make Replacement Implement Bolts - Method #2
• How To Make A Replacement Lift Rod For The Leveling and Grader Blade

[Rudi]

All About Tools, Jigs, Special Parts and Equipment


Equipment For Your Cub



• How To Make Kodiak's Cub Splitting Stands
  
• How To Make Tractor Splitting Stands from Scaffold Jacks
• How To Make 3 Types of Splitting Stands from Scaffold Jacks
• How To Make Rick Dulas's Tractor Jack Stands
• How To Make Ricky Racer's Tractor Jack Stands
• How To Make Todd W's Tractor Splitting Stand
• How To Make Dave Winfield's Easy Tractor Stand
• How To Make Frederick's Plywood Splitting Stands
• How To Make One Piece Tie-Downs
• How To Make and Install Tire Chains
• How To Make A Belly Mower Dolly
• How To Make A Blade Cart
• How To Make A Sickle Mower Blade Guard
• How To Mount A Pony Tank
• How To Make A Temporary or Pony Gas Tank
• How To Make A Rear Weight Installation Helper