Switch to full style
Got a project that you are working on that is not a tractor? Maybe a barn to hold your tractors or just fun stuff like woodworking, glass, tools, sheds, gardens, custom implements, etc., this is the place to talk about it.
Post a reply

Re: Powder Coat Curing Oven

Tue Oct 16, 2012 8:03 am

My old booth was built out 2 x 4 and melemine sheeting sold a lowrs and home depot. Worked great but the fire marshal inspected it and didnt like it. Now i have a sheet metal booth.

Re: Powder Coat Curing Oven

Tue Oct 16, 2012 10:51 am


What is there to laugh about :?: :?: I think it is innovative - creative - functional - frugal --- use what you have to build what you need. Personally I think it looks good.

You might want to skin it in at some point, but I see no real need.

You got me thinkin :idea: :arrow: :lol:

Re: Powder Coat Curing Oven

Tue Oct 16, 2012 11:39 am

Here is a really bad picture of the PC spray booth I built this weekend. All in all it cost me about $15 but I did have the electrical stuff on hand already. Nothing fancy no blower (Might add that in later) just something to keep the powder for going all over.


I also added a regulator for the PC gun so that I don't have to keep turning down my main air supply.
I added rods across the top to hang items from (They were from an old metal shelf .....thought I would never use them and would hang onto them forever but they worked perfectly here).

Re: Powder Coat Curing Oven

Wed Oct 24, 2012 6:10 am

Well I picked up another little piece of the puzzle last night. I managed to find a 30 ft 50 Amp 125\250V extension cord for $40 on Craigslist. It was a great deal as the 6 gauge cable alone would have cost me way more than that. This will allow me to move my oven wherever I want in my shop.

50 Amp Extension Cord.jpg

The picture doesn't do this thing justice.....It is a monster!....the cable is about 1 1/2 " in diameter....a heck of an extension cord for sure!

Re: Powder Coat Curing Oven

Wed Feb 13, 2013 7:35 am

Well finally an update.....I am going to purchase the steel to continue on the oven. I have decided to use 3/16ths plate for the floor and use 3 x 3 x 3/16ths angle going up each corner. This will allow me to hang a LOT of weight in the oven without worry. Hopefully I can post some pictures in the next week or so with the completed floor and corners. Then start on installing the sheet metal skin and insulation.

Re: Powder Coat Curing Oven

Thu Mar 28, 2013 6:43 am

Started installing the 26 gauge sheet metal skin...was pretty reasonable at $25 for a 4 X 10 sheet......and I put it on its base. Next I will locate the corners and weld in the 3" angle that will be going up each corner. So far it is going as I had expected.

PC Oven with inner sheet metal and base:
PC Oven.JPG (47.76 KiB) Viewed 215 times
Post a reply