Posted: Mon May 17, 2004 10:49 pm
OK>
started this thread on April 25 it now the 17 of may after new piston rings and bored 10 over. new valves done by me once and by the local head shop machinist ( after it would not start)set at .006 intake .010 exhaust. new solid state module (after it would not start)soaked the carb and rebuilt with complete kit(after it would not start) finally got it to start by putting some oil in the cylinder I am right back to where i started it runs till it gets hot then dies. Took it back to the machinist he check the valves and guides again took a little more off the exhaust and it seems to run a little longer but still dies.
so can anyone look up the valve spec or tell me were i can find them I have access to a older B&S manual IT show
Aluminum Cylinder Intake .005-.007 Exhaust .009-.011
Cast Iron Cylinder Intake.007-.009 Exhaust .014-.016
IT Is a B&S Model 195432 8HP Industrial /Commercial Aluminum block with a cast iron bore
weeds are getting tall
thanks
started this thread on April 25 it now the 17 of may after new piston rings and bored 10 over. new valves done by me once and by the local head shop machinist ( after it would not start)set at .006 intake .010 exhaust. new solid state module (after it would not start)soaked the carb and rebuilt with complete kit(after it would not start) finally got it to start by putting some oil in the cylinder I am right back to where i started it runs till it gets hot then dies. Took it back to the machinist he check the valves and guides again took a little more off the exhaust and it seems to run a little longer but still dies.
so can anyone look up the valve spec or tell me were i can find them I have access to a older B&S manual IT show
Aluminum Cylinder Intake .005-.007 Exhaust .009-.011
Cast Iron Cylinder Intake.007-.009 Exhaust .014-.016
IT Is a B&S Model 195432 8HP Industrial /Commercial Aluminum block with a cast iron bore
weeds are getting tall
thanks