The Buzz Saw's Back
Mon Feb 28, 2005 6:55 pm
I finally got around to making a blade guard for my buzz saw and another improvement I call the "CLAW". With the CLAW you don't have to get anywhere near the blade. Everything can be done from the left side of the saw. Here's a couple of pictures. I'll bet you can tell George didn't make them! By the way Welcome Back George!
[img][img]http://pic4.picturetrail.com/VOL758/2886648/5823280/87316357.jpg[/img]
[/img]
Mon Feb 28, 2005 8:42 pm
Just getting all the pieces to mine. I had my Grandad's blade and finally got a saw. It looks a lot like yours. Looks like yours has a tilting table?
Lot's of work to do to mine yet!
Lot's of work to do to mine yet!
Mon Feb 28, 2005 9:32 pm
Brent, looks like quite a job, and a lot safer than the original. but sure would take some of the excitemnet out of using it. did you leave the blade open or enclose it on the back edge. If enclosed chips getting caught there may be a problem.
Mon Feb 28, 2005 10:19 pm
John,
It's enclosed but there's about 3" of clearance between the blade and the top of the guard. So far no problem with chips getting clogged.
It's enclosed but there's about 3" of clearance between the blade and the top of the guard. So far no problem with chips getting clogged.