Sun Aug 05, 2012 10:37 am
My friend in the fire service the other day was looking at his trailor axle on his enclsed trailor a little smaller than Barnyards.
He found that he had a serious problem. So he ask me where he could get some parts I told him tractor supply. I didnt know they use plastic bushing. He was one lucky person. This for everyone that has tamdom axle trailor flat or enclosed to check this hardware out for ware.
If this nneds moved please do.
You do not have the required permissions to view the files attached to this post.
Sun Aug 05, 2012 12:32 pm
For those that have excess to a Metal lathe, like myself, I removed each each bolt ( one at a time ) , drilled a 1/8 " hole half way down from the "head side", then in from the side of the shank of the bolt, finally drilling / taping correct threads for a 1/4 " grease zerk , installing same, and now I have greaseable joints that will last a "life time" ! Maybe the best end result, "PIECE OF MIND", that they are not worn out or break apart, missing my tractor event ! Lee, Joliet, IL.
Sun Aug 05, 2012 1:15 pm
Jeff Silvey wrote:.......... So he ask me where he could get some parts I told him tractor supply...............
Another is http://www.etrailer.com/
I have used them a couple times. They have a detailed website.
Sun Aug 05, 2012 1:25 pm
much better place than Tractor Supplyhttp://www.redneck-trailer.com/
Mon Aug 06, 2012 6:21 am
Thanks for the reminder, Jeff, I'm going to look mine over today.
Mon Aug 06, 2012 8:14 am
I have seen that before, it is common on older trailers. You can get the parts at places like Red Neck Trailer parts, or at Red Line. as well as many others.