Fri Jan 16, 2004 8:38 pm
So this blade I got has been outside for a while and is pretty rusted. What is the best way to attack it in preparation to a good paint job?
Fri Jan 16, 2004 9:06 pm
No question about it... sandblasting. Preferably by someone else, at their site. You'll get a good cleanup to bare metal without health risks and you won't have any of the mess.
The next step, although you didn't ask... I have my sandblast guy do the primer too.
I think it saves money too.
Sat Jan 17, 2004 9:32 am
Thanks George, would it be a good idea to get all the nuts/bolts broken free and replaced, then give the "disassembled" blade to a sand blast guy?
Sat Jan 17, 2004 10:12 am
Yes, that would be an excellent plan. Make any repairs first. If you're like me, you'll find enough other stuff to take too to make a trailer load.
Sat Jan 17, 2004 8:23 pm
Guy- Theres A place in Savege, Not far from you, Vally Equipment I think, Otherwise check with body shops, They usualy have smaller units that work good and primer and paint. "Jack" PS. I lost your Ph# ,E-mail me again.
Sat Jan 17, 2004 9:32 pm
Thanks Jack, I sent you an email.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.