Internal Hydraulic Leak

Farmall Cub Forum -- Questions and answers to all of your Cub related issues.

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.

Internal Hydraulic Leak

Postby Mark Fredricks » Sun Jan 18, 2004 6:41 pm

I have just bought a 1956 Cub, My Grandfather had one just like it. It runs fine, but the hydraulic pump leaks into the engine crankcase. Being new to the Cub family, I don't know if there is a gasket/seal that needs to be replaced or complete rebuild. Any information would be greatly appreciated. Happy Cubbing!!!
Mark Fredricks
 
Posts: 1
Joined: Sun Jan 18, 2004 6:29 pm

Postby Bigdog » Sun Jan 18, 2004 6:49 pm

Mark, there has been a lot of discussion about this lately. There are o-rings in the hydraulic pump that are bad, allowing fluid to leak into the crankcase. The pump is an easy rebuild and should solve your problem
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.

My wife says I don't listen to her. - - - - - - - - Or something like that!

http://www.cubtug.com
User avatar
Bigdog
Team Cub
Team Cub
 
Posts: 23814
Joined: Sun Feb 02, 2003 12:50 pm
Location: OH, Stoutsville
Zip Code: 43154
Circle of Safety Award
Circle of Safety: Y

Postby Donny M » Mon Jan 19, 2004 5:44 pm

Mark,
Try this link http://farmallcub.com/phpBB2/viewtopic.php?t=2343
There's not too much to the pump as you will see when you get it apart. If you replace all of the "O" rings this should solve your problem. Inspect the drive shaft to make sure it's smooth and not worn too bad. Mine had a nice groove worn into it where the "O" ring seals (or not) I had to clean it up by taking a few K's off the dia. then used a smaller "O" ring. It works fine now.

Good luck,
Donny
Donny M
 


Return to Farmall Cub

Who is online

Users browsing this forum: Dennis and 7 guests