This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Anybody ever taken a distributor apart.
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
- 10+ Years
- Posts: 613
- Joined: Mon Feb 03, 2003 1:18 pm
- Zip Code: 27055
- Tractors Owned: 1951 Super A
1955 Cub Lo-boy
1955 Ferguson TO-35 - Circle of Safety: Y
- Location: NC, Yadkinville
Anybody ever taken a distributor apart.
My distributor was soaked with oil up where the points are at when I tore my engine down. Now that I am reassembling, I have taken it apart and cleaned it up. It is pretty straight forward. The distributor shaft has a pretty good groove in it where the seal rides. The seal on this is an o-ring in a little brass carrier instead of a lip seal. Will a new o-ring seal in this groove? If not what are my options. I imagine a new shaft would be pricey, IF you could even get one. I don't think there is room (lengthwise) for a speedy-sleeve. Any suggestions?
The four most expensive words in tractor restoration: "We might as well..."
- RedNed
- 10+ Years
- Posts: 481
- Joined: Mon Feb 03, 2003 6:32 pm
- Location: Long Island,New York
Who is online
Users browsing this forum: No registered users and 25 guests