Sun Feb 15, 2004 4:19 pm
I have some striped out bolt holes on my final drives, do these have to be removed to be repaired. What is the best thread repair for theses holes I believe they are 5/8 by 11 tpi. thanks
Sun Feb 15, 2004 5:36 pm
I would think that a heli-coil repair could be done right on the tractor. Make sure you drill square...maybe a drill jig that sits flat on the casting would be in order. But maybe someone else on the board has some experience with this.
Sun Feb 15, 2004 7:08 pm
Charles: I used a heli-coil in doing the same repair on a final drive. I did this a couple of years ago and have had no problems up to this time. It should work for you. Dan
Sun Feb 15, 2004 7:23 pm
Charles- On high end stuff like aircraft heli-coils are installed on parts when they are new. It makes the threads more durable and strong then they would otherwise be in the base material. My own experience is they not only provide a good repair butt the repair may be better than it was originally, if done correctly.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.