While rebuilding the hydraulic piston assembly on my Grandpa's 1951 Cub, I ran into a problem. Removing the Regulator Valve Seat. After several different failures my cousin came up with this idea.
I purchased a Blackhawk 3/4" Deep Well Impact Socket at Carquest.
3/8" Drive Impact Set at Northern Tool
3/8" Pittsburgh Deep Well Impact Sockets at Harbor Freight
Individual sockets may be available as well.
I measured the width of the slots of the Regulator Valve Seat with small straight screwdriver. Then I transfered the measurements to the socket and using a bench grinder and some water to keep it cool, I ground it out to fit the valve seat. I finished up by deburring it with a file and some sand paper.
Here are a couple of pictures of the end result.
If anyone knows where to buy a tool like this, please let me know.
Time saving tips to keep your Cub running smooth
Moderator: Team Cub
1 post • Page 1 of 1
- 10+ Years
- Posts: 42
- Joined: Thu May 17, 2007 8:53 pm
- Location: Wilkes County, North Carolina
- Similar Topics
- Last post
by AL Farmall Boy
Fri Mar 30, 2018 11:10 am
Thu Sep 07, 2017 10:30 am
Tue Oct 27, 2015 1:21 pm
Sun Aug 09, 2015 8:12 pm
Thu Jun 07, 2018 4:17 pm
Who is online
Users browsing this forum: No registered users and 0 guests