Need measurement from lo-boy
Moderator: Team Cub
2 posts
• Page 1 of 1
Need measurement from lo-boy
by Daniel H. » Mon Mar 01, 2004 10:07 pm
I'm still playing with adapting the Allis-Chamlers gear box to the cub to slow down and reverse the PTO but I need to know the distance from the center of the PTO shaft to the inside of the left (viewed from rear) fender to see if I have enough clearence. Since my cub is in pieces I can't measure it. Thanks!
The four most expensive words in tractor restoration: "We might as well..."
- Daniel H.
- 501 Club
- Posts: 543
- Joined: Mon Feb 03, 2003 1:18 pm
- Location: NC, Yadkinville
by George Willer » Mon Mar 01, 2004 10:28 pm
Daniel,
It should be the same as a regular Cub, 5 1/2". I'm sure you will want to mount the gearbox so the offset is as far as possible to the right. You may have to add an elbow to the vent.
It should be the same as a regular Cub, 5 1/2". I'm sure you will want to mount the gearbox so the offset is as far as possible to the right. You may have to add an elbow to the vent.
George Willer
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
http://gwill.net
The most affectionate creature in the world is a wet dog. Ambrose Bierce
-
George Willer - Cub Pro
- Posts: 7011
- Joined: Sun Feb 02, 2003 9:36 pm
- Location: OHIO, Fremont
- Zip Code: 43420
- Circle of Safety: Y
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: BIGHOSS, chet larsen, Clark Thompson, Eugene, Winfield Dave and 9 guests
|
|