PTO advice needed

Dennis (51) · Postby **Dennis (51)** » Sun Mar 07, 2004 6:32 pm

My Cub came with a belt pully adapter on the PTO. Now i want to hook up a mower and need to reconvert to a standard PTO. What do I need to do the job?

I checked the TM Tractor Parts website and it appears that a "pto shaft oil seal & bearing retainer" is all I'll need. Am I correct? Any advice from the masters?

Dennis (51)
(The Other Dennis)

Postby **George Willer** » Sun Mar 07, 2004 7:10 pm

Dennis,

If I understand your question right... just simply un-bolt the right angle drive and put it aside. You will have to replace the bolts. The pulley drive is a self-contained unit.

Dennis (51) · Postby **Dennis (51)** » Sun Mar 07, 2004 8:17 pm

George, I never thought it would be that simple. I'll give that a try tomorrow. BTW, I've officially declared the end of Winter in Virginia by removing the tire chains. Still got the snow blade on cuz they're predicting some "flurries" next week. Keep your fingers crossed...

Dennis (51)

Postby **Rudi** » Sun Mar 07, 2004 8:22 pm

I was going to remove my chains from Ellie this week as well. Snow seemed to be going and spring was to finally arrive.

Oooops :oops:

spoke to fast :!:

Rained yesterday for about 5 hours then it turned to ice and to snow last night. I now have 2 foot drifts in the shop driveway, although we only have about 3 inches down in total. Winds were pretty high. Lost power today for 3 1/2 hours as well.

Sooo, I guess I will be keeping the chains on for a while longer :roll:

Dennis (51) · Postby **Dennis (51)** » Mon Mar 08, 2004 6:53 pm

Rudi,
Life is tough sometimes. It would be a lot tougher if we didn't have Cubs.

Postby **Rudi** » Mon Mar 08, 2004 8:17 pm

Dennis:

Cubs are the reason Winter is still so much fun :!:

Farmall Cub

PTO advice needed

PTO advice needed

Who is online