Thu Mar 11, 2004 9:34 pm
I'm installing the govenor seal in the crankcase and I am not clear on the instructions. Should the side of the seal with the spring be to the govenor or the distributor?
Thu Mar 11, 2004 10:04 pm
Thu Mar 11, 2004 10:10 pm
The spring should be toward the distributor. The open side of the seal faces the governor. The governor has a gasket between it and the block to keep oil from leaking out. The seal keeps oil away from the distributor.
Thu Mar 11, 2004 10:34 pm
The spring should go toward the governor. Cub-Bub said it both ways.
Jim showed it all.
Fri Mar 12, 2004 7:47 am
Attached is a good article on oil seals. As Donny said, spring should face governor.........Bill V.
Fri Mar 12, 2004 2:31 pm
Thanks for the help!
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.