idea, but wonder if you could make the correct size retainers?
I was just browsing thru the local Mom & Pop hardware store for some things I need as I try to figure out another project, and came across "Nut Caps" there in the bin. Those are those "Top Hat" shaped little metal buckets that slip over the end of a screw or bolt.
Wonder if you could find a size close enough to work, and use something like that to make your own retainers?
The other 2 options I see that you have is to have it milled to accept the larger retainers. Or perhaps another brand carb uses that size?
Might try taking a trip to a lawnmower repair shop, and see if that size is used on some of the mower engines? Or maybe another brand of tractor?
Last edited by Into Tractors on Wed Sep 26, 2007 6:27 am, edited 1 time in total.