Farmall Cub

by **john2189** » Tue Dec 04, 2007 2:01 pm

anyone know what the torque is for the rod bearings on an H motor ?

John

by **Bob Underwood** » Tue Dec 04, 2007 4:30 pm

Service Manual calls for 55 ft lb on an M. I doubt if there would be much difference. Book does say the bolts are 7/16.
Bob

by **Cub-Bud** » Tue Dec 04, 2007 4:40 pm

According to the I&T manual, connecting rod bolt torque for an H should be 40 ft. lbs. Main bearing bolts should be torqued to 75 ft. lbs.

by **john2189** » Tue Dec 04, 2007 10:04 pm

thanks guys

by **WKPoor** » Tue Dec 04, 2007 11:16 pm

Goodandtight!!! Did you wire your mains like you should????

by **john2189** » Wed Dec 05, 2007 5:23 pm

yes, they are wired

torque for rod bearings