Fri Jan 25, 2008 6:33 pm
Could someone tell me how long these bolts are. I have all 4 broken off and need to be drilled out. Thanks
Fri Jan 25, 2008 6:51 pm
If you hit water, you went too far.
Look at the bolt call-out (part number 110 500) under items 18 and 19:
Fri Jan 25, 2008 7:02 pm
Be sure you don't get a real sharp drill bit
. No you can't ask what I mean by that
Fri Jan 25, 2008 7:15 pm
Step 1: Carefully grind existing screws flush to the bolster.
Step 2: Carefully center punch the screws.
Step 3: Mark a #25 drill bit about 5/8" up from the tip by wrapping with a bright colored tape (i.e. masking tape or electrical tape).
Step 4: Carefully drill out the "offending" screw.
Step 5: Carefully chase the threads with a lubricated 10-24 tap using a manual tap holder. The left side (looking from drivers seat toward front) is easy. The right side is a challenge. The front screw is difficult. The rear screw can only be done with a long tap.
Take your time and you'll be fine.
Sat Jan 26, 2008 11:02 am
After you drill out the screws, be careful with the tap. I know whereof I speak. I broke one off in the hole. No drill bit I tried could drill out that hardened steel. I finally got it out with a Dremel diamond dust covered tip. But then the hole was too big; so I threaded the hole for a quarter inch screw. Then I drilled the proper sized hole in the screw and threaded it. It worked, but you don't want to have to go through all that!
Sat Jan 26, 2008 11:09 am
and don't drill too deep, the cast between them and the water is not real thick at that point.
Sun Jan 27, 2008 2:06 pm
In my opinion, this has to be towards the top of the list of flawed designs of IH. Along with the teeth design of the throttle. I like the AC B design thicker steel all around the throttle assembly.
Sun Jan 27, 2008 8:12 pm
Clem wrote:In my opinion, this has to be towards the top of the list of flawed designs of IH. Along with the teeth design of the throttle. I like the AC B design thicker steel all around the throttle assembly.
The main problem with the IH throttle teeth is people sliding them instead of pulling them out of the notches to move, then setting back in at the spot needed. I have worn out some myself before I learned that.
Sun Jan 27, 2008 8:19 pm
This is true, but should be expected that people would do the opposite, especially after many years of production. I would assume that the farmers had their complaints back then about it.
Mon Jan 28, 2008 1:29 am
Even sliding them, most probably lasted for the intended 15 years or so.
Mon Jan 28, 2008 3:11 am
Remember the design life
of the Cub was only 7 years
. No one envisioned that they would be so viable 61 years later
Who knew huh
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.