Hi All,
Does anyone know what size bolt will fit the hole on the end of the crankshaft? (front)
It looks to be a 9/16 or 5/8.
Thanks,
Ron
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
Bolt size
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
- Bigdog
- Team Cub Mentor
- Posts: 24144
- Joined: Sun Feb 02, 2003 12:50 pm
- Zip Code: 43113
- Circle of Safety: Y
- Location: OH, Circleville
- Contact:
I believe that's a 1/2" - NC
Bigdog
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
If you can't fix it with a hammer, you've got an electrical problem.
My wife says I don't listen to her. - - - - - - - - Or something like that!
http://www.cubtug.com
- Ken (48 Cub)
- 10+ Years
- Posts: 994
- Joined: Mon Feb 03, 2003 11:10 am
- Zip Code: 40023
- Tractors Owned: 1948 FCub
1957 LoBoy - Circle of Safety: Y
- Location: KY, Fisherville
-
- 10+ Years
- Posts: 80
- Joined: Sat Feb 08, 2003 11:23 am
- Location: Columbus, Georgia
Bolt size
Thanks to all who responded!!
After I finally got the fan pulley off, I discovered that the threads in my crank
have been gone for some time.
It appears that they were pulled out.
I was able to tap the deeper, smaller hole to a 7/16 x 14 so I would at least have something.
I believe I would have to go up to at least a 5/8 size to re-thread the outer part of the crank.
Thanks again!!
Ron
After I finally got the fan pulley off, I discovered that the threads in my crank
have been gone for some time.
It appears that they were pulled out.
I was able to tap the deeper, smaller hole to a 7/16 x 14 so I would at least have something.
I believe I would have to go up to at least a 5/8 size to re-thread the outer part of the crank.
Thanks again!!
Ron
1951 Farmall Cub
Who is online
Users browsing this forum: Jim Becker and 49 guests