Rear Axles leaking

Farmall C, Super C Tractors, 200 & 230 1948-1958

Moderator: Team Cub

Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
10+ Years
10+ Years
Posts: 355
Joined: Sun Jun 18, 2006 7:49 pm
Zip Code: 64870
Tractors Owned: 1950 Cub..1951 Farmall Super C...1949 Farmall H
Circle of Safety: Y
Location: Webb City, Missouri

Rear Axles leaking

Postby kthomas » Sat May 24, 2008 8:23 am

Hi all,

I have a 1951 Super C. It leaks grease where the rear axles go into the housing on both left & right sides. I see that there are 4 bolts that hold what looks like a seal retainer. For those of you that have had this problem, is there in fact some type of seal here, and I'm guessing it is a pretty simple job to replace them?

1950 Cub...1951 Super C

Cub Pro
Cub Pro
Posts: 6617
Joined: Thu Aug 31, 2006 7:00 pm
Zip Code: 02769
Tractors Owned: 6"F" cubs
5 lo-boys
1 154
1 184
1 IH444
1 Oliver OC3 crawler
1 AC D10
1 IH 100 manure spreader
1 IH model B corn grinder
3 power units
cub demonstrator
Circle of Safety: Y
Location: Ma. Rehoboth

Re: Rear Axles leaking

Postby ScottyD'sdad » Sat May 24, 2008 4:44 pm

If it's built like the cub and A, you need to press the bearings off the axle, to change the seals. Ed
Member of Chapter 18, and National
Circle of Safety

Daniel H.
10+ Years
10+ Years
Posts: 608
Joined: Mon Feb 03, 2003 1:18 pm
Zip Code: 27055
Tractors Owned: 1951 Super A
1955 Cub Lo-boy
1955 Ferguson TO-35
Circle of Safety: Y
Location: NC, Yadkinville

Re: Rear Axles leaking

Postby Daniel H. » Sat May 24, 2008 7:15 pm

Here is the parts breakdown. You can go to: and see the parts list. Click on "Click here to begin your search." on the lower left side of the page and then enter "Super C' under model.

001CSIH-40686 (Small).gif

Click the picture to make it bigger.
The four most expensive words in tractor restoration: "We might as well..."

10+ Years
10+ Years
Posts: 6343
Joined: Sat Jul 22, 2006 5:02 pm
Zip Code: 00000
Location: in northern usa

Re: Rear Axles leaking

Postby BigBill » Sun May 25, 2008 8:25 am

If the old seal wore into the axle. When i change seals(any type) I don't hit in the new seal to were the old seal was. I keep them a tad shallow so they have a new surface to seal on rather than were its worn from the old seal. I do this on crankseals too, any type of seal were there is a worn spot(ring). You can adjust were the seal rides by installing it in a different position.
I'm technically misunderstood at times i guess its been this way my whole life so why should it change now.

  • Similar Topics
    Last post

Return to “Farmall C, Super C, 200 & 230”

Who is online

Users browsing this forum: No registered users and 0 guests