Tue Jun 16, 2009 9:30 am
I plan to have road bands made for my 1934 F12 and 1944 H (both on steel). Does anyone have any photos of what they would recommend as a good design? I suppose they could be a single band around the lugs then clamped or welded to connect, or 4 sections of band each attached seperately to the lugs, a full width band or perhaps a 1/2 width band. I suspect once I put them on they will not be needed to be removed.
Any ideas or suggestions are welcome,
Tue Jun 16, 2009 12:53 pm
I would suggest bolting strips of old tire to them for traction loading and unloading. Smooth steel is mighty slick with even the slightest hint of moisture.
Tue Jun 16, 2009 5:59 pm
Following in EJPs advise, rubber belting would work too (I believe) Something from a quarry would probably work the best. I think it's always reinforced (nylon).
Thu Jun 18, 2009 12:05 pm
Thanks, iIfound a couple folks interested in making them and they too suggested I install "Amish rummer" on them, srj
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.