Namco fork lift

Steve Butram

501 Club
I just picked this up to move stuff around the shop . It has an Onan engine in it and runs on propane. I haven't been to successful in finding any information on it.

namcoforklift003.jpg


namcoforklift002.jpg
 
Thanks Eugene I'm surprised that there is no web site out there that deals with these. I'm spoiled by this site :lol:

It is a LC 2015 Serial # 7211906


It will need some new tires in the future but it will be fine fore the winter I plan on repainting it sometime. And depending on what the starter costs to repair I may think about re-powering it with another engine
 
http://www.schaeffinc.com/selectdealer.asp

A list of Schaeff dealerships.

Couple of suggestions. E-mail the Schaeff corporation and ask their engineering/archive/historical department it they have any information on your lift.

Contact the Schaeff dealership in your area, asking for same information.

Starter for Onan engine. Onan parts are still available - expensive. The starter should/will be still available. It will take some research. Typically the starter was used by several engine manufacturers. Look for the same starter but used on say a Briggs engine - will be cheaper.

Other lift parts will/should be available - after identification.
 
I work for a Hyster dealer but we can get just about anything under Nacco group and have a huge aftermarket availability for lift trucks, PM me if you need a qoute or anything I'll see what I can do to help if anything is needed.. Josh
 
Cool Steve

I have a electric Joe. But I have to push it around and it only lifts a 1000lbs about 60". That forklift looks really handy :{_}: :{_}: :{_}: :{_}:


Billy
 
That motor looks like a CCK or CCK A Onan. Very common 25 30 yrs. ago. Available in everything from Garden Tractors to RV generators. Starters were very durable. A common problem was the wire becoming disconnected on the pos. stud. inside the starter. A little difficult to get at but definately repairable.
 
Back
Top