Sun Aug 01, 2010 5:23 pm
On a 3 point hitch I have on one of the arms the ball were you hook up to a implement its missing can the ball be replaced or does the whole arm have to be replaced.
Sun Aug 01, 2010 6:06 pm
Replace the ball, weld a small bead around the opening, and peen it in to hold the ball. I think Shoup has the balls.
Sun Aug 01, 2010 6:41 pm
Often implement dealers have stub arm ends about 3-4 inches long with the ball. The stub is welded to the existing arm after cutting the old end off.
Not near you , but available here. http://orders.leinbachs.com/cart/machinery/
Mon Aug 02, 2010 6:32 am
You can also get just the round portion, with the ball in it to weld to your old arm. Don't know if they still do, but TSC had both styles a while back.
Fri Aug 06, 2010 5:44 am
Just cut a piece out of the end of the loop, heat and bend the two together and weld it shut. Usually no need to replace the ball.
Fri Aug 06, 2010 8:05 am
DanR wrote:Just cut a piece out of the end of the loop, heat and bend the two together and weld it shut. Usually no need to replace the ball.
That works if one is coming out, but I believe his is missing.
Fri Aug 06, 2010 12:29 pm
TSC has the ball only.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.