Sat Sep 18, 2010 2:54 pm
I need information on how to take the spindle out of the fan hub on my Farmall A. I have it off the braket that secures it to the tractor but am unsure how to get the rest apart.All and any suggestions are needed.
Mon Sep 20, 2010 9:14 am
you have to take the blade off, under there is a nut that has to be removed. keep a mental note of the oil slinger direction, that is the only difficulty in there.
Mon Sep 20, 2010 7:24 pm
Thanks Phillip, I had planed on replacing the assembly but after I took it apart I found I did not need to. It was full of grease and there was a little end movement, but otherwise seemed tight. Thanks again, Randy
Mon Sep 20, 2010 10:28 pm
Clean the grease out and oil it per the Owner's Manual. I don't think that grease in there will ever get to where it needs to be.
Tue Sep 21, 2010 7:57 pm
Hi Jim, Thanks for responding. There is a grease fitting opposite of the oil fill plug. When that compartment gets full of grease it forces itself down the length of the shaft and comes out the other end. I think it may work this way. Thanks for your suggestion. Randy
Tue Sep 21, 2010 8:45 pm
Fitting probably installed by a previous owner.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.