IHC Cub Cadet Forum -- Questions and answers to all of your Cadet related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
4 posts • Page 1 of 1
After getting the 100 running real nice I thought I was going to move on to the hydraulic lift, but after a few trial runs I noticed the battery seems to always be low. I put the meter on it, and no charge. First thing I decided to do is to clean the connections. Some were pretty bad, so I have to stop and pick up some properly sized ring terminals on my way to work. Then I noticed there was a ring terminal on the terminal on the rear of the Voltage Regulator, but no wire. After looking through a couple of my other manuals (no manual for a 100 yet) I am under the impression that it should be a ground. Is that the case? If not, what color of wire goes there? I have an extra aqua-greenish-blueish- wire that seems to go nowhere, I assume it goes to my non functioning headlights?
1947 Circle Cub, 193, 189
1954 Cub w/FH, IH100, 194, F11
1956 Cub Loboy w/FH and 194
1960 Cub Loboy w/FH and L-54
1953 Super A, 2 seater B, Avery V, Avery A, JD M, MH Pony, Leader D, Allis Chalmers C, and my Great Grandpa's ZA Minneapolis Moline.
What is the letter under the regulator terminal? If the leter is an "L", not a ground.
Go to Cub Cadet, Parts look up. There is a wiring diagram the 102.
I have an excuse. CRS.
If the 100 has the correct voltage regulator on it, that terminal is for the GEN. One side of the VR should have F or FLD, Bat, and L or Load. The other side or bottom should had a Gen terminal, and that bluish/greenish wire connects to that terminal and the other end connects to starter/generator "A" terminal.. The correct VR is grounded thru the VR mounts and does not have a ground terminal. The wire colors are:
VR Gen to generator A, Light blue
Generator A to starter button, Red
VR "F" to generator F, Yellow
VR Bat to stsrter button, Gray
VR "L" to ignition switch, Light Green
Ignition Sw to coil +, Black
Coil - to points, Black
Condenser to coil -.
Some other VR's do have a bottom side GRN or Ground terminal, but those do not have a "L" terminal.
4 posts • Page 1 of 1
Who is online
Users browsing this forum: AC and 2 guests