130 pto

[jwmcd]

I am working on a farmall 130. The pto shaft seal leaks. I have removed the housing, but cannot get any gear puller I have to fit the gear. Not enough clearance between the gear and the housing. The manuals I have are not clear on how to remove shaft and seal. Any suggestions? Thanks, jwmcd

[artc]

i'll look at my super A tonight. i've got to take it apart anyway

[artc]

the gear can be removed using a std 3 jaw puller inserted in the three internal holes in the gear after removing the bolt and washer, of course. i reinstalled the bolt without the washer to push against.

then remove the woodruff key, and drive the pto shaft out of the housing. the two bearings are the same IHC L-230 (1206AG Timkin)
now the seal can be changed.

hope this helps, art

[jwmcd]

Thanks Art. Very helpful info. I kinda thought that was the way, but neither of my gear pullers would fit in the holes. Now to find a smaller size puller. John

[jwmcd]

I finally got it off. Thanks again for your help Art.>>John