130 pto

Thu Mar 10, 2011 10:06 am

I am working on a farmall 130. The pto shaft seal leaks. I have removed the housing, but cannot get any gear puller I have to fit the gear. Not enough clearance between the gear and the housing. The manuals I have are not clear on how to remove shaft and seal. Any suggestions? Thanks, jwmcd

Re: 130 pto

Thu Mar 10, 2011 10:15 am

i'll look at my super A tonight. i've got to take it apart anyway

Re: 130 pto

Fri Mar 11, 2011 4:26 pm

the gear can be removed using a std 3 jaw puller inserted in the three internal holes in the gear after removing the bolt and washer, of course. i reinstalled the bolt without the washer to push against.

then remove the woodruff key, and drive the pto shaft out of the housing. the two bearings are the same IHC L-230 (1206AG Timkin)
now the seal can be changed.

hope this helps, art
Last edited by artc on Tue Mar 15, 2011 8:49 am, edited 1 time in total.

Re: 130 pto

Sat Mar 12, 2011 9:49 am

Thanks Art. Very helpful info. I kinda thought that was the way, but neither of my gear pullers would fit in the holes. Now to find a smaller size puller. John

Re: 130 pto

Wed Mar 16, 2011 9:06 am

I finally got it off. Thanks again for your help Art.>>John