belt pulley housing
Moderator: Team Cub
3 posts
• Page 1 of 1
belt pulley housing
by leroy68 » Thu Jun 23, 2011 10:45 pm
Pulled mine off bearing looks good but leaking a little around outside of shaft should oil seal fix this problem? What else do i need to do since i have it off?
- leroy68
- Posts: 28
- Joined: Thu Jun 02, 2011 8:31 pm
- Zip Code: 30520
Re: belt pulley housing
by leroy68 » Thu Jun 23, 2011 10:49 pm
Is there suppose to be a gasket behind the plate on the right side where the oil seal is at
- Attachments
-
- leroy68
- Posts: 28
- Joined: Thu Jun 02, 2011 8:31 pm
- Zip Code: 30520
Re: belt pulley housing
by Dale Finch » Thu Jun 23, 2011 11:26 pm
If you remove the retainer, #48, you'll need to replace the gasket #47. Don't think it was necessary, though, when just replacing the seal #49.
http://www.cleancomputes.com/Cub/Super%20A%20-%20Super%20AV/TC-39B%20Parts%20Catalog/Page%20268.jpg
Dale F
http://www.cleancomputes.com/Cub/Super%20A%20-%20Super%20AV/TC-39B%20Parts%20Catalog/Page%20268.jpg
Dale F
Dale Finch
-
Dale Finch - 501 Club
- Posts: 1055
- Joined: Tue Apr 27, 2010 11:34 am
- Location: NC, Chapel Hill
- Zip Code: 27517
- Tractors Owned: '55 Cub "Bertha"
'52 Cub "Bobbie"
'48 Super A "Bubba"
'48 Super A (parting out) 
- Circle of Safety: Y
3 posts
• Page 1 of 1
Return to Farmall A, Super A, AV
Who is online
Users browsing this forum: No registered users and 0 guests
|
|