Does anyone have the head bolt torque sequence for a Farmall MD? I looked all through the service and operators manuals but it is not listed anywhere.
It gives the torque spec as 110 ft. lbs. but that is it.
Or do I just start in the middle and work out in a circular pattern in multiple steps?
Thanks in advance for any help.
Jeff
MD head torque sequence.
Moderator: Team Cub
2 posts
• Page 1 of 1
MD head torque sequence.
by Jeff D. N.E. Wis. » Sat Jul 02, 2011 1:12 pm
49 Farmall Cub, 68 I-H Cub LoBoy
53 Farmall Super-A, 44 Farmall B
52 Farmall Super-C, 41 Farmall H
40 Farmall M, 46 Farmall M
51 Farmall MD, 50 Case DC-3
54 Case 500 Diesel
71 Allis-Chalmers 160 Diesel
53 Farmall Super-A, 44 Farmall B
52 Farmall Super-C, 41 Farmall H
40 Farmall M, 46 Farmall M
51 Farmall MD, 50 Case DC-3
54 Case 500 Diesel
71 Allis-Chalmers 160 Diesel
- Jeff D. N.E. Wis.
- Cub Star!
- Posts: 243
- Joined: Mon Feb 03, 2003 2:00 pm
- Location: WI Sturgeon Bay
- Zip Code: 54235
- Circle of Safety: Y
Re: MD head torque sequence.
by Phillip W. Lenke » Wed Jul 06, 2011 8:49 pm
Start in th middle and work out , i set the torque at 30 torque all the keep going up that way you keep thepressure constant alll over going up 20 to 30 each passtoo reach the specified torque.
hope this helps
Phil
hope this helps
Phil
"Work Hard ,Play Often,Care Always"
- Phillip W. Lenke
- 501 Club
- Posts: 1474
- Joined: Wed May 25, 2005 1:21 pm
- Zip Code: 43449
2 posts
• Page 1 of 1
Return to Farmall M, Super M, 400, 450, & 560
Who is online
Users browsing this forum: No registered users and 0 guests
|
|