Farmall Super A, AV, 1939 - 1954
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
9 posts • Page 1 of 1
I just installed my new Brillman wiring harness (VERY NICE!) on my SA which had been converted to 12v. I must have told them something wrong, because as I was hooking it up, I realized that I didn't have the wiring for the almost forgotten coil resistor. I actually thought it belonged to the parts SA until today when I went through the photos and realized it was on this tractor.
So my question is, is there a coil made that does NOT have the external resistor? Is it rediculously expensive? I just hate to add/delete wires from a brand new wiring harness. Anyone want to trade?
Thanks, Dale F
Dale, the way i understand it, the points and condensor need the reduction in voltage to prevent overheating and thus early failure.
you will just be adding the one small jumper in your pic.
Dale, to avoid tampering with your shiny new harness, just connect your resister in series between the coil & the dist. It doesn't care which side it's connected to.
To answer your original question, an internal resistor 12V coil is available at NAPA for a little over $20. The number is IC14SB.
MD, Deep Creek Lake
"1950 Something" Farmall Cub
1977 International Cub w/FH
1978 International Cub
1948 Farmall Super A
1951 Farmall Super C w/FH
A bit of clarification: In the photo above, one wire went to the coil (rear/left wire), and the other (forward/right) wire went around the front to the alternator on the left side.
So where exactly do the 2 resistor wires go? In the photo the wire on the other coil terminal already goes to the distributor.
PS The $20 NAPA coil may be the easiest solution...what's another $20 when I have spent 3x the value of the tractor on parts already!!! I just laugh when someone asks if I am doing this to sell it! !
The resister is normally between the switch and the coil. in your instance, the same switch also provides power to the exciter, so they connected it at the alternator exciter connection rather than running 2 wires from the switch.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
Hmmmm...I should be able to figure this out, and maybe if I am standing there looking at the harness I will. I do know how to read a wiring diagram, but they did not send one with the harness...only numbered terminals with directions for where to connect them. I think I will draw a diagram, then perhaps I can figure it out.
So ultimately the goal is what? IF I have the rest of the tractor wired per Brillman's instructions, can I simply put this in series between the coil and distributor, as in between the left/rear coil wire and the dist? I will see just what wire is attached now to the OTHER coil terminal.
$20 is looking cheaper every question!
i personally prefer the internal coil route. simpler and cleaner. the resisters get hot and can be a source of failure.
'If they're tappin', they're not burnin'
Just spoke witht he NAPA guy, and one new resistorless-coil is on its way to the shop!!! Thanks once again for your advice and support!
PS Got the drawbar and rear rockshaft on so far today, plus some little piddling stuf!!
9 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest