Mon Aug 15, 2011 7:32 pm
I read about this a while back and decided to give it a try today after work. Found a short piece of feed line at the shop and I picked up a .75 cent box of baking soda.
Boy was I ever amazed with the results, the carb looks like new again.
Took only a few mins. and yes I recommend some type of face cover for breathing.
I also believe this could be done very easy while the carb's on the tractor...
Very pleased, shocked and amazed.
Mon Aug 15, 2011 7:34 pm
looks good Yogie,,on my list of things to try
Mon Aug 15, 2011 7:37 pm
I have been meaning to give that a try. The results are impressive.
Mon Aug 15, 2011 7:44 pm
Wow! Yogie that looks great
Mon Aug 15, 2011 7:58 pm
Looks Great, Yogi! I need to do the same. Pabst!
Mon Aug 15, 2011 8:05 pm
That looks fantastic! Nice work
Mon Aug 15, 2011 8:20 pm
Looking good. I need to get me one! Ed
Mon Aug 15, 2011 8:24 pm
Seeing is believing, but it is hard for me to understand how a medium that feels so soft in texture can clean so effectively.
Mon Aug 15, 2011 8:27 pm
Looks right purdy,
just like a new one. Great job.
Mon Aug 15, 2011 8:32 pm
very nice results, and minimum of cost, a good combination. good job yogie, i think i will try it myself. coppersmythe............................
Mon Aug 15, 2011 8:58 pm
How many PSI are you using?
Mon Aug 15, 2011 9:31 pm
challenger wrote:Seeing is believing, but it is hard for me to understand how a medium that feels so soft in texture can clean so effectively.
I went over it several times when only one swip was all that was needed. I was amazed that the gas stains, dirt and all just disappeared.
Mark In Richmond wrote:How many PSI are you using?
Mark, we run around 150 lbs but while doing this job I held the air blower about half open, it really doesn't take much pressure to do the job.
I highly recommend geting some type of breathing cover for protection. Even the cheap rubber band toss aways would help a lot.
Mon Aug 15, 2011 9:36 pm
Nice fabrication Yogie , what did you use for the little gun H.F.?
Mon Aug 15, 2011 10:27 pm
daddydip wrote:Nice fabrication Yogie , what did you use for the little gun H.F.?
Any type of blow nozzle will work, I picked that one up at Walmart.
Tue Aug 16, 2011 1:33 am
Pretty neat stuff--knew you'd like the results
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.