Sat Feb 04, 2012 4:33 pm
Well, I have the 154 pretty much in a million pieces. Engine looked pretty good, had 1 broken ring but no damage to cyl wall. My lifters have a pretty good amount of pitting and was wondering what is acceptable, and I don't want to buy a used set in the same condinion. Should I use these or get better ones? Thanks
Sun Feb 05, 2012 10:57 am
Pitted on the lobe face or on the sides?
Sun Feb 05, 2012 6:59 pm
On the lobe face, sides look fine.
Sun Feb 05, 2012 9:29 pm
I'd replace them. At best the surface hardness is chipping away and they'll only get worse quickly.
Sun Feb 05, 2012 9:44 pm
Sounds about right. I'll give hamiltonBob tomorrow.
Sun Mar 04, 2012 2:20 pm
y older valve grinder had an attachment for resurfacing the lifters. Unless there really bad. Make sure you install them with some moly on them. It will reduce the first start up wear that happens too.
Sun Mar 04, 2012 5:37 pm
I just gave them a hand lapping. You can really see a difference. Lubriplate no. 105 on everything. This is somewhat of a budget rebuild. Nothing was bad enough to replace except the wear parts- bearings and rings, nothing was broken except for 1 ring. I've been dealing with a certain machine shop for 35+ years so they know me well and don't try to sell me anything I don't need. Crank bearings were all at .002 and we'll see what the rods and rings look like when I get them. I will order them tomorrow from TM.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.