Farmall Super A, AV, 1939 - 1954
Moderator: Team Cub
5 posts • Page 1 of 1
Well I've gotten past all my electrical problems and couldn't wait to fire her up.Turned on the fuel,no leaks until I started turning it over. Then came the flood of gas out the bottom.Went to TSC and bought a rehab kit for it.Cleaned all the passages replaced needle valve and seat and new gasket.Put it back on and the same situation.I've read that the carter's are bad boys.The float isn't taking on fuel and works freely.You guys have gotten me this far so I'm asking,am I missing something or should I get rid of the carter and try to find a Zenith?I've had it on and off to check so many times I can't count.Everything looks and works as it should but still it leaks.As always any help would be appreciated.
Don't toss out that Carter UT. They really are a pretty good carb. Must be cause they were on the Super A's as well ... just need to be done properly.
"Before beginning a hunt, it is wise to ask someone what you are looking for before you begin looking for it." - Winnie
Cub Manual Server
Mine used to do the same thing. I finally got tired of trying to adjust by the book and adjusted to where I thought for sure it would starve for fuel. It runs perfect, but shut off the gas when you park it, or it will drip. I also just put a kit in it.
Aim Low, Acheive Your Goals.
My Super A #4 AKA Old Ugly has a Carter and it also seems to be pretty drippy.....tractor runs good though. I don't think A's came factory with Carter carb's but IH must've been putting them on Super A's hot and heavy in '50 because both of those tractors have Carter's on them. The Zenith sure looks simpler to me....
"12 volt conversions are for quitters"
IH's are RED. Just say NO to yellow and white!
Let us pray for farmers and all who prepare the soil for planting, that the seeds they sow may lead to a bountiful harvest.
Check for a fault in the needle valve and seat area.
Bench test for fault. Carburetor top upside down on bench. Plastic hose connected to carb inlet. Elevate plastic hose and fill with rubbing alcohol.
I have an excuse. CRS.
5 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests