Tue Sep 25, 2012 8:11 pm
Anyone had any luck making a sediment bowl gasket? I cleaned my Sediment Bowl and now won't go back together without leaking. Old gasket seems good but apparently not. I've check with all the tractor parts places here but no luck and don't have time to order one before Cubruma. I'd sure hate to not bring my 55 lo-boy because of a $1.00 gasket.
Tue Sep 25, 2012 8:22 pm
Have you tried Tractor Supply or NAPA? I have had luck with theirs.
Tue Sep 25, 2012 8:35 pm
napa has the good rubber ones, they keep them in stock here
Tue Sep 25, 2012 9:04 pm
Thanks - I'll be checking with NAPA tomorrow.
Tue Sep 25, 2012 9:09 pm
Are you sure you have the screen in right? there is a channel it is supposed to set in.
Tue Sep 25, 2012 9:38 pm
And the screen goes under the gasket.
Tue Sep 25, 2012 11:52 pm
I have tried to make sediment bowl gaskets out of almost every material under the sun - paper, plastic, inner tube rubber, magazine covers, tool box drawer liners - all with no success.
I have had great success cutting them out of a roll of cork. If you have the old gasket simply trace around the outer and inner edges and cut with scissors. If you don't have the old gasket trace around the glass bowl and guesstimate or find a suitable item like a shot glass for the inner edge.
I was at Tractor Supply the other day and noticed a roll of cork for only nine bucks. Wow. Wasn't it only a couple of bucks the last roll I bought?
If you can't find a roll of cork try scavenging some from a pin up board or an old gas can cap or spout.
Wed Sep 26, 2012 6:04 am
My Tractor Supply carries a screen and gasket package...It is not labeled for Cubs...but it fits and works perfectly.
Wed Sep 26, 2012 6:33 am
You should be able to get the gasket from about every tractor dealer. That type filter is very common. I got one from a JD dealer.
Fri Nov 09, 2012 8:43 pm
Does anybody have the part # for the Napa sediment bowl gasket? Thanks
Fri Nov 09, 2012 8:54 pm
730-9506. May want to take your glass bowl with you just to be certain if you can
Fri Nov 09, 2012 9:06 pm
Thanks for the information Chris D! Hopefully this will fix my leaky fuel strainer.
Fri Nov 09, 2012 9:09 pm
Rubberized cork gasket material works well for that. However, as others have stated, they are easy enough to find that I wouldn't mess with trying to make one.
Also, I have to ask, are you tightening the nut on the bottom of the bowl upon installation?
Fri Nov 09, 2012 9:20 pm
I installed an new fuel strainer purchased from Tractor Supply. Upon attaching to the gas tank I did tighten the bottom nut however, after starting and running I noticed fuel leaking on the bell housing.
Fri Nov 09, 2012 10:47 pm
tighten the packing nut on the valve
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.