Mon Oct 08, 2012 1:04 pm
Tue Oct 09, 2012 9:17 am
Tue Oct 09, 2012 9:30 am
Tue Oct 09, 2012 9:41 am
CapeCodCubs wrote:Rudi...what the heck is a wakee? Will you be bringing a translator to New York?
Tue Oct 09, 2012 9:50 am
Tue Oct 09, 2012 10:26 am
Denny Clayton wrote:CapeCodCubs wrote:Rudi...what the heck is a wakee? Will you be bringing a translator to New York?
In the Marine Corps back in the '60's and 70's it was a "wakeup".
Tue Oct 09, 2012 11:03 am
Tue Oct 09, 2012 11:07 am
Tue Oct 09, 2012 2:34 pm
Peter Person wrote:Ed,
You're supposed to put the whammy on CTCubFest, not Cecil's
Looks like we might be spending a lot of time inside. Hopefully this improves.
Tue Oct 09, 2012 2:45 pm
I'd like to bring a tractor to pull the tranny. I believe It needs a front and/or rear input shaft bearing.
Tue Oct 09, 2012 6:37 pm
Tue Oct 09, 2012 7:50 pm
Buzzard Wing wrote:Gary, the seals and gaskets are more than $100. I have been doing my tranny in baby steps... possibly so I wouldn't know how much it costs! From what I have seen of a lot of transmissions there is or was water in mix. Cub bearings will probably 'work' forever after a water/oil mix, but I replace em when I have it apart.
Interesting bit about water and bearings:
http://www.machinerylubrication.com/Rea ... ng-failure
Wed Oct 10, 2012 6:27 am
Wed Oct 10, 2012 6:32 am
Thu Oct 11, 2012 6:46 am