Wed Oct 31, 2012 2:17 pm
Just wondering if anyone has used the Steiner clutch kit with the "true" Bearing TO bearing as opposed to a graphite one. I'm ready to split my 73 for a new clutch,pp,t.o. bearing. I like the idea of a real bearing, but if no one has tried it here, I'd be leary of it.
Thu Nov 01, 2012 7:04 am
99 views and no answers makes up my mind. It looks like TM gets my business again, but thats a good thing.
Thu Nov 01, 2012 7:51 am
You won't be disappointed with TM.
Thu Nov 01, 2012 9:45 am
I've had real good luck with them in the past. I just ordered over 400.00 in parts from them.
Thu Nov 01, 2012 10:34 am
There's been quite a bit of spirited discussion about the steel ball throwout bearings over the years, but not as much lately.
In a nutshell you're better off with graphite. One problem is that the TO bearing isn't necessarily perfectly centered on the clutch fingers so there's always some "scrubbing" going on. The graphite bearing is designed to scrub. A steel bearing will wear out and fail quickly.
I think the biggest issue with the steel TO bearings is poor quality.
Thu Nov 01, 2012 11:10 am
Sorry that I don't have much information about the TO bearing discussion...I'd love to help, however, on your split and work on the tractor if you'd like help!
Thu Nov 01, 2012 12:54 pm
Mike, thanks for the offer. I'm doing this with my son in his garage as I only have a carport. What a difference moving from a 5 bedroom farmhouse on 3 acres in Illinois to a 2 bedroom bungalow on a lot 25'x155' in PA ! The place in IL was getting too much for me to take care of. My main concern now is getting my 53 Cub and my 53 SA here to PA. I'll definately have some attachments to sell, as my son made a road trip and brought them all back here with my 73 Cub with the bad clutch. We've never split a Cub before, but we'll just go by the book and if we run into trouble, you'll be getting a call.
Thu Nov 01, 2012 9:48 pm
Sorry I cant help!!---I have never had a clutch go out of any of my tractors, so I dont even know what they have in them! thanks; sonny
Thu Nov 01, 2012 11:46 pm
As many of the more knowledgeable forum members have said: If the original has lasted 40 yrs, the graphite bearings can't be THAT bad
Fri Nov 02, 2012 7:47 am
I have a clutch kit like that in mine. The PO installed it just before I bought the tractor. The only things ive noticed are the fingers need to be adjusted out to their maximun right off the bat in order to have any adjustment at the pedal. The bearing type TO wont wear like the graphite, so I assume thats not an issue. I also have one finger that will not stay in adjustment. Im not sure why, but i doubt it has anything to do with the TO bearing. I might try some locktite on the stud, as it is the stud backing out of the finger, not the jam nut getting loose. Other than that ive had no problems.
Sat Nov 03, 2012 7:09 am
Clodhopper, Thanks for the product update. I'm glad I went with the TM parts now.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.