Oil Pressure

[LeeC]

My oil pressure reads high on the gauge and hardly backs down when the engine is warm (running 10W-30). I was going to check the regulator to see if it is stuck, but I am unsure how to get to it. The plug sits in a recess that gives very little clearance for a socket. Also, one of the bolts that connect the engine to the bolster is in the way and does not want to come loose easily, so I went to plan B. I tried a box end wrench and there are a number of things that get in the way. What is the best way to get at the pressure regulator plug? Given this apparently easy operation has hit unexpected snags, where is the best place to hook up a pressure gauge to make an accurate measurement? I would assume removing the tractor oil pressure gauge and connecting it there or is there another preferred location? Thanks, Lee

[lazyuniondriver]

I would proceed exactly as you describe by hooking up a new or known to be accurate oil pressure gauge in same location as the suspected defective gauge.

Until actual oil pressure is known, avoid disassembly of other components.

[LeeC]

Sound advice. Rather than using another cub gauge that I would have to take off another tractor, I have a mechanic's oil pressure gauge/tester. I was wondering where the best location is for hooking it up. I guess I have my answer. I still would like to know how to get at that pressure regulator plug if it comes to that. Thanks, Lee

[Eugene]

Depending upon the sizes of the fittings in your oil pressure testing unit or oil pressure gauge, there is an allen plug in front of the oil filter housing.

Since a bolt holding the engine to bolster is in front of the oil pressure regulating valve, you will need to remove the bolt. Or remove the nut to loosen the bolt then slide it back a bit into the bolster.