Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
6 posts • Page 1 of 1
Hey guys and gals. I have not been a member but a few days and I need some help here. I rebuilt my 1953 cub from top to bottom. I did the seals bearings compleate engine you know all of it. I have been getting it back together, had a few problems with carb had to take apart a few times. But what was bugging me was I set up just enough to check my engine out. It would run great for about five minutes and it sounded like it would lock up and cut off. It would start right back and would run great. What i FOUND WAS MY HYDRAULICS ARE BUILDING PRESSURE AND BOGGING THE engine down (sorry about the caps). Could some one help me with this. as long as i shift the hydraulics it runs great soon as I stop moving them bam locks down. Thanks Mark C
Sounds like there is a restriction somewhere. I would suggest reading the GSS-1024 - Touch Contro Serviceman's Handbook. There is a good troubleshooting section there as well. I would look at problem 9 in the trouble shooting section.
Hydraulics will load an engine down, but should not stall it out once the engien is warmed up. sounds like you may have a couple of problems. Assuming you have the original touch control rather than an external system, the bypass should open before it builds that much pressure. Also , unless you are moving the lever there should be no load at all.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
Is this a new malfunction and did the touch control system work correctly since you have owned the tractor?
Has someone recently rebuilt the touch control system?
I have an excuse. CRS.
there is a restriction orfase in the in the flow of oil in the lowering position. This is to keeping impliments from falling too fast. There should be a slight load when lowering the hydraulices but if it stalls the engine then there is only 1 of 2 tings it could be. The hydraulic fluid is too thick or the orfase is pluged. May have a piece of O ring or gasket blocking it. There is a filter screen on the orface or there should be.
Collector of Farmall cubs and cub cadets.Injoy helping people keep their cubs running. Years of experipnce.
6 posts • Page 1 of 1
Who is online