Tue Dec 11, 2012 12:41 pm
5/16" - 18 thread with 1/2" hex head cap screw, per parts book.
Tue Dec 11, 2012 1:35 pm
I have never had a problem removing or replacing the bolt some times you will have to take the coil off , but a short 1/2 in boxed end wrench works fine for me. I do not like to leave it off and will replace it if it is missing.
Tue Dec 11, 2012 1:36 pm
bythepond88 wrote:That should be a 1/2" bolt.
Just to clear up any confusion here... The correct size bolt is 5/16. That bolt takes a 1/2 inch wrench.
Tue Dec 11, 2012 1:42 pm
Do you needs some Don?
Tue Dec 11, 2012 2:15 pm
I have been using the same wrench shown by Eugene for many years, that is the only wrench that works for me. and I don not reinstall the back bolt when I remove it now.
Tue Dec 11, 2012 4:40 pm
Boss Hog wrote:Do you needs some Don?
The bolt or the clamp?
No to either. I just didn't want someone throwing them in the trash.
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.