Heater Update

Thu Dec 20, 2012 10:31 am

Well the new board is in. When I disconneted the wire the ignitor part that was soldered in the board one leg came out. I think that was the problem. What do I know I always get a hammer. On the new board had revised stamped on it. So its working. Just in time for the winter stuff coming in.

Re: Heater Update

Thu Dec 20, 2012 10:44 am


Good stuff :D When customers provide feedback it sometimes is useful in constructing the revision and solving the problem. Looks like you are benefiting from that. Will look forward to your experience with this heater so I can pass it along to my buddy up the street for his shop :D

ImageMerry Christmas

Re: Heater Update

Thu Dec 20, 2012 5:51 pm

Put the pin back in place and solder it so you have a spare. That is if you don't have to return it.

Re: Heater Update

Fri Dec 21, 2012 8:10 am

I'm glad you got it going, Jeff! That's a nice little heater!