Farmall Cub Forum -- Questions and answers to all of your Cub related issues.
Moderator: Team Cub
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
9 posts • Page 1 of 1
I can only start cub in gear, when pushing on clutch pedal it does not release clutch. After removing inspection cover to see clutch, i found that one of the adjusting screws was missing, can this adjusting screw be replaced. Also why wont tractor move when it is in neutral.
Thanks for any help
Depends on which clutch you have as to what part is needed.
If your Cub's Serial Number ends in J then you probably have a Rockford Clutch - see the drawing below:
If there is no J at the end of the Serial Number you may well have an Auburn Clutch - see the drawing below:
Either way the parts are available and can be sourced from a number of places - check with our sponsors below such as TM Tractor or Carter and Grunewald for new parts and JP Tractor or possibly Hamilton Bob (he usually deals in numbered series Cubs but one never knows). There is also the classified forums here on the site that can be useful as well.
For the not moving in neutral, I imagine you are stuck between gears so you will have to look in the tranny under the shifter - see the drawing below:
Reading the GSS-1411 Service Manual for Cubs and Lo-boy Tractors Revision 1- Section 6 - Transmission And Differential section is a good start. I am not all that comfy with tranny's - I am still learning how to get them unstuck. I had my 47 stuck between gears and I rocked her back and forth a number of times -- couple dozen anyways and all of a sudden she came free. My problem was a bit of rust forming between moving parts - as I had drained the tranny and only had kerosene in it to clean. Needless to say once she was unstuck, SAE 90Wt went into the tranny pronto.
It could be the shift forks are not lining up. With the shifter in neutral remove the top of the trans. The forks should be in line. If not, you will have to tap them so they do line up. Once they are in line the tractor should roll. A couple of thinks could cause them to get out of line. A worn shifter is one another is a broken fork. Of course they may have been forced out of line while attempting to fix the problem initially. Inspect every thing for damage and if none is found put the top back on, making sure the stick is still in neutral position. It may jump right back out (in which case you need to look again for a problem), or it may work fine with no further problems.
Sea salt is healthier only because it gets stuck in the holes of the shaker and you can't actually put it on your food.
Barnyard Bash CubFest May 30th - May 31st, 2014
Click here for info.
Thanks Bill, I keep forgetting the forks......... this might help Tranny Repair 101
Unless I'm misreading some thing, the tractor shouldn't move when in neutral. The transmission needs to be in gear for the engine to transmit power to the wheels. If you mean it won't role when in neutral then the transmission is stuck in two gears at once and as stated above is probably a fork problem.
I assume you are starting in gear so as to be able to drive the tractor, if this is correct and the tractor moves as it should I don't think that you have any type of transmission problem.
I don't know from first hand experience, but I have seen where others said they were able to replace the adjusting screw.
Mark "birddog" Birdeau
I don't know the back ground on this tractor or when it quit moving when in neutral. However, with the cold weather here in Ohio this week the transmission could be frozen. I have seen this happen where there is a lot of water in there.
9 posts • Page 1 of 1
Who is online