No overflow tube on radiator

[Dan Stuckey]

Getting some odds and ends done on my cub and one thing I'd like to address is the overflow on the radiator. The tube is broken off the neck. Did I see on this forum a fix for this. Something like a hollow bolt or something in that order. Could find it on the search but was sure I had seen in here.

[Barnyard]

Dan, I remember something like that too. As soon as I find it I will lock it down in the how to forum.

[Boss Hog]

Yes there is one on here somewhere, Bear did it. 1/4 in brass screw with a hole drilled in it works well. I thought it was saved but guess not

[Barnyard]

Here you go. I have copied it into the How To forum.

viewtopic.php?f=138&t=75812

[Boss Hog]

viewtopic.php?f=1&t=57488&p=473506&sid=aad5ad41afe34600b301499d27e494be#p473506

[Boss Hog]

I should have looked it up before I told who did itBy the way that should be put in the how too section

[Cubfriend]

Cub tip of the week December 5, 2010. Good luck!!

[Barnyard]

I should have looked it up before I told who did it

I wish I had seen who did it before I started looking. It took a couple different search strings to find without an author but I figured it would have to pop up sooner or later.

[Yogie]

I searched a while and gave up, glad it was saved.

[ntrenn]

I bent me a piece of 1/4" copper tubing to where I wanted it, flared the end inside the neck, then JB Welded the junction at the radiator. Took about 10 minutes and overnight to set up....