Sat Jan 05, 2013 11:14 pm
Getting some odds and ends done on my cub and one thing I'd like to address is the overflow on the radiator. The tube is broken off the neck. Did I see on this forum a fix for this. Something like a hollow bolt or something in that order. Could find it on the search but was sure I had seen in here.
Sat Jan 05, 2013 11:31 pm
Dan, I remember something like that too. As soon as I find it I will lock it down in the how to forum.
Sat Jan 05, 2013 11:33 pm
Yes there is one on here somewhere, Bear did it. 1/4 in brass screw with a hole drilled in it works well. I thought it was saved but guess not
Sat Jan 05, 2013 11:42 pm
Here you go. I have copied it into the How To forum.viewtopic.php?f=138&t=75812
Sat Jan 05, 2013 11:43 pm
Sat Jan 05, 2013 11:45 pm
I should have looked it up before I told who did it
By the way that should be put in the how too section
Sat Jan 05, 2013 11:51 pm
Cub tip of the week December 5, 2010. Good luck!!
Sun Jan 06, 2013 12:04 am
Boss Hog wrote:I should have looked it up before I told who did it
I wish I had seen who did it before I started looking. It took a couple different search strings to find without an author but I figured it would have to pop up sooner or later.
Sun Jan 06, 2013 11:24 am
I searched a while and gave up, glad it was saved.
Sun Jan 06, 2013 1:11 pm
I bent me a piece of 1/4" copper tubing to where I wanted it, flared the end inside the neck, then JB Welded the junction at the radiator. Took about 10 minutes and overnight to set up....
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.