Wear Sleeve Installer

Time saving tips to keep your Cub running smooth

Moderators: Barnyard, Team Cub

Wear Sleeve Installer

Postby Jdbfish » Sat Jan 19, 2013 10:00 pm

Use a 1-1/2" PVC coupler fitting as shown:

Image

Saw the coupler fitting lengthwise in 2 places removing a section approximately 1/4 to 2/3rds of the total circumference. This will reveal a molded step in the ID (which I marked in black for clarity) as shown:

Image

Then saw the coupler fitting's overall length to approximately 1-1/2" - 1-3/4" as shown:

Image

Slide the short end of the coupler fitting over the wear sleeve until the step hits the edge of the wear sleeve as shown:

Image

Tighten a hose clamp around the modified coupler fitting to keep it from spreading open or moving around. Then use a wood block on top of the coupler fitting and hammer it onto the crank pulley as shown:

Image

All done!
Jdbfish
Cub Star
Cub Star
 
Posts: 98
Joined: Mon Nov 12, 2012 9:52 pm
Zip Code: 76502

Return to Engine, Clutch, Transmission and Hydraulics

Who is online

Users browsing this forum: No registered users and 0 guests