Sun Feb 03, 2013 1:01 pm
ended up with A 8 volt battery end of last summer. Not what I wanted but all they had at the time so , it is in the loader cub and has set too long. had it hooked to 6 vt. maintainer but still dead in this cold weather.
can I hook a 12vt. charger too this battery
Sun Feb 03, 2013 4:23 pm
No, but you could hook 3 of them to a 24v charger (truck, bus, aircraft). Eight volt battery would need about 9v to charge.
Sun Feb 03, 2013 4:40 pm
You get what you pay for and you pay for what you get.
Sun Feb 03, 2013 7:55 pm
Use your 6 volt battery charger or battery charger on 6 volt setting. Depending on charger voltage output on 6 volt setting, should charge the battery up to 7.5 to 8.0 volts.
Something wrong, bad battery or electrical drain. Take battery to auto parts store and have tested.
Wed Feb 06, 2013 5:11 am
First thing I do with the 8-v junk here is take it out and toss it into the garbage and go get 6-v. ---OR better yet is go 12-v. conversion!---the 8-v kills all the voltage system, (gen. reg. light bulbs, coil, burns up the points fast!)---oh, and it dont turn the engine over any faster than 6-v!!---2 of my cubs came with 8 stuck in them and did not run, (ign. smoked) charge system roached out totally and now I have to keep charger on the new 6 in them because I cant afford to fix all the damaged stuff!---currently using only the 12-v jobber IF I use a cub! thanks; sonny
Wed Feb 06, 2013 8:54 am
The Cub is back to 6 volt, were both happy
Powered by phpBB © phpBB Group.
phpBB Mobile / SEO by Artodia.