Farmall Cub Forum
Moderator: Team Cub
5 posts • Page 1 of 1
You guys have been alot of help in giving advice on my 53 cub rebuild. I have learned a lot. The main thing was make sure you find a good machine shop.
My problem with the engine stalling was Crank out of line, cylinders not correct and oil channels full of all kind of gunk. The oil pressure piston was also full of gunk and stuck. well lessons learned i am sure i will have a good running tractor when i get the parts back and put back together. I have learned alot. I can put the engines together with no probles Thanks again.
I JUST HAVE ANOTHER QUESTION. Is there two types of cranks for the cub. I order two on ebay and took them over to the machine shop without checkig them since he was doing that anyway. He called me this afternoon and said one had heaveir counter waits than the other one. I forgot to ask him if they had the same numbers. Any knowledge to this would help me a lot thanks Mark C
One with heavier counterweights was probably form a power unit such as baler or combine. They ran at higher RPM. Alos make sure it is drilled for clutch pilot bearing.
"The Constitution is not an instrument for the government
to restrain the people, it is an instrument for the people to restrain the
government lest it come to dominate our lives and interests." Patrick Henry
There are 2 crankshafts and 2 different styles of rods. You can use new rods on old cranks but you can't use old rods on the newer style crank so be careful. Here is a thread on the topic. http://www.farmallcub.com/phpBB2/viewtopic.php?f=1&t=74507&p=598038&hilit=crankshaft#p598038
I'd get the part numbers off the cranks and then report back to us. I just checked several manuals on Rudi's server and there appears to be several choices, ranging from early cranks up through numbered series cranks. It appears that the bailer/thresher crank was the same number as the early crank(251 264 R1) and the revised crank that Bob spoke of was the 527 456 R1 that used different rods and bearings.
When I told my dad I've been misplacing things and doing stupid stuff----His reply---"It only gets better"
There were two types of crankshafts. In the early cubs say about very early 47 IH used a forged steel crankshaft. It was prone to braking at the center main. . I H recalled all the forged steel cranks. But that doesnt mean they all got replaced. All the specks were the same as far as the journels. I have run into a few of the forged steel cranks still going strong. I have a 57 loboy that has a steel crank. It is used hard. I suspect the reason for the steel crank in my 57 is it was rebuilt at sometime with a crank out of a early cub. I have had many power unit engines over the years.I have yet to find a steel crank in any of them.
Collector of Farmall cubs and cub cadets.Injoy helping people keep their cubs running. Years of experipnce.
5 posts • Page 1 of 1
Who is online