Sun Apr 07, 2013 7:23 pm
Sun Apr 07, 2013 7:26 pm
Sun Apr 07, 2013 7:37 pm
Sun Apr 07, 2013 7:59 pm
Sun Apr 07, 2013 8:04 pm
Sun Apr 07, 2013 8:16 pm
Mon Apr 08, 2013 5:33 am
Mon Apr 08, 2013 8:15 am
Mon Apr 08, 2013 8:20 am
jim turner wrote:Barney, I use the boomarang on my hand lift for the grader blade is this not correct?
Mon Apr 08, 2013 8:57 am
It will bolt on, but the hole where the lift rod attaches does not line up with the one in the rockshat.Barnyard wrote:jim turner wrote:Barney, I use the boomarang on my hand lift for the grader blade is this not correct?
Jim, You would still use a boomerang regardless of which rockshaft you have, but it is my understanding the boomerang on a manual lift rockshaft will not fit a TC rockshaft.
I have never tried the straight rod with a handlift, but sighting along the mounts it appears that it would rub sometimes, especially if the hole is in the top hole of the hand lift.Bill E Bob wrote:I noticed in the illustration, the use of a straight rockshaft rod, yet the drawing shows a long ear dash.
Is the requirement for an off set rod unnecessary when using a manual lift?
Mon Apr 08, 2013 10:00 am
tst wrote:#1 hand lift front rockshaft
#2 rear rockshaft lift rod
#3 are cub loboy C2 & C3 mounting brackets
#4 do not think its for a cub