Well, I thought that I had my carb all set to remount on the CUB after cleaning, getting the choke unstuck, and putting in a new float. Now I discovered that the long brass tube that goes from the top casting to the bottom casting parallel to the float is broken off and I have NO IDEA how to get it out. Was looking forward to getting the CUB running, but not sure how to handle this issue.
Baldwindiesel
This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy
NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.
More Carb problems
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
-
baldwindiesel
- 10+ Years
- Posts: 252
- Joined: Tue Sep 11, 2012 9:21 pm
- Zip Code: 44820
-
Bob McCarty
- Team Cub
- Posts: 11850
- Joined: Tue May 25, 2004 8:02 pm
- Zip Code: 80501
- Tractors Owned: Cubs, MH Pony, Shaw, Allis G, 1934 Silver King, JD LA and LI, Gibson D, David Bradley Tri-Trac
- Circle of Safety: Y
- Location: CO, Longmont
Re: More Carb problems
That's the idle tube. The threaded end is in the top of the carb and is where the calibrated orifice is. Your carb will most likely run okay with it broken. If you want to remove and replace it, the threaded end is 4-48. The long piece should be sprayed for several days prior to removing it. Sometimes you can pull them out, often they must be carefully drilled out.
Bob
Bob
"We don't need to think more,
we need to think differently."
-Albert Einstein
we need to think differently."
-Albert Einstein
-
baldwindiesel
- 10+ Years
- Posts: 252
- Joined: Tue Sep 11, 2012 9:21 pm
- Zip Code: 44820
Re: More Carb problems
Bob:
Thank you ! I will put it on the CUB and give it a try. Hopefully I will at least get it running and can IRON out the little carb problems later.
Baldwindiesel
Thank you ! I will put it on the CUB and give it a try. Hopefully I will at least get it running and can IRON out the little carb problems later.
Baldwindiesel
-
Barnyard
- Team Cub
- Posts: 24262
- Joined: Tue Aug 07, 2007 3:39 pm
- Zip Code: 45030
- Tractors Owned: At This Time
40 Farmall Cubs (Round Hood)
2 Farmall Cub (Square Hood)
2 IH Cubs (Square Hood)
5 Lo-Boys (Round Hood)
2 Lo-Boys (Square Hood)
2 Farmall 404's
1 Farmall H
1 Ferguson 20
1 Cub Cadet 125
1 Kubota B-7100 - Circle of Safety: Y
- Location: OH, New Haven (Hamilton County)
- Contact:
Re: More Carb problems
baldwindiesel wrote:Hopefully I will at least get it running and can IRON out the little carb problems later.
If it runs okay and you want to replace the tube later bring it on down to the Bash the end of May and we can get it out.
There are two ways to get enough Cubs. One is to continue to accumulate more and more. The other is to desire less.
Who is online
Users browsing this forum: Garvin Gatewood and 13 guests
