This site uses cookies to maintain login information on FarmallCub.Com. Click the X in the banner upper right corner to close this notice. For more information on our privacy policy, visit this link: Privacy Policy

NEW REGISTERED MEMBERS: Be sure to check your SPAM/JUNK folders for the activation email.

throw out bearing replacement

The Cub Club -- Questions and answers to all of your Cub related issues.
Forum rules
Notice: For sale and wanted posts are not allowed in this forum. Please use our free classifieds or one of our site sponsors for your tractor and parts needs.
Post Reply
TJG
10+ Years
10+ Years
Posts: 1224
Joined: Wed Jul 02, 2008 6:11 am
Location: MN, Mankato

throw out bearing replacement

Postby TJG » Thu Jul 04, 2013 8:39 am

How much side-to-side free play should be present when replacing the TOB on the pin that goes through the bell housing? I have about 3/8 inch which can allow the TOB to be slightly off center. I'm wondering if I need a washer/spacer on each end of the pin to keep the TOB assembly centered.

Thanks,

Todd
Top

SPONSOR AD

Sponsor

Sponsor
 
Top
Post Reply

Return to “Farmall Cub”

Who is online

Users browsing this forum: Glen and 51 guests